Labour on a 5×7 bathroom remodel typically runs $3,000 to $7,000, usually 40 to 60 percent of the total project cost. A 5×7 is the standard American full bathroom at 35 square feet, and the labour splits across five trades: demolition, plumbing, electrical, tile setting, and finish carpentry.
How much is labour for a 5×7 bathroom remodel?
Typically $3,000 to $7,000, which is usually 40 to 60 percent of the total project cost. Here’s how that splits across the five trades involved in a standard 5×7 remodel:
| Trade | Typical Cost Range | Share of Labor Total |
| Demolition | $300 – $800 | Smallest single line |
| Plumbing | $500 – $1,500 | Higher if fixtures move |
| Electrical | $400 – $1,000 | Higher with new circuits |
| Tile Setting | $1,200 – $2,500 | Usually the largest line |
| Finish Carpentry | $600 – $1,200 | Trim, vanity, hardware |
| Total Labor | $3,000 – $7,000 | 40–60% of full project |
These are typical ranges, not a quote — your actual numbers depend on your specific bathroom’s condition and what’s involved in each trade’s scope. The pattern to notice is that tile setting consistently runs highest, which the next section explains.
How big is a 5×7 bathroom?
35 square feet. It’s the standard American full bathroom size, normally fitting a toilet, a vanity, and a tub-shower combination along the seven-foot wall.
What percentage of a bathroom remodel is labour?
Generally 40 to 60 percent. The share rises when plumbing is relocated and falls when the project is mostly fixture replacement.
This is the number worth anchoring your budget expectations to if you searched for “labor” specifically rather than just overall cost. It also explains why two quotes with similar total prices can look so different line by line — a quote weighted more toward labor usually reflects more plumbing or layout work, while one weighted more toward materials usually means a more straightforward, fixture-replacement job.
Which trade costs the most in a bathroom remodel?
Tile setting is usually the largest single labour line, because it is time-intensive and the finish quality depends entirely on the skill of the setter.
Every tile has to be individually cut, placed, and leveled, and grout work adds further time on top of that — there’s no way to meaningfully speed this up without the finish quality showing it. This is also exactly where a cheap quote tends to cut corners: rushed tile work is visually obvious (uneven lines, sloppy grout) in a way that’s hard to fix without redoing it. For ways to reduce this specific cost without sacrificing the result, see our small bathroom remodel cost guide, which covers large-format tile as a genuine labor-saving choice.
Can I save money by doing demolition myself?
Some, but less than people expect — demolition is typically a small share of the labour.
Looking at the table above, demolition is the smallest single line to begin with, so even doing it entirely yourself only saves a modest amount relative to the whole project. The bigger risk is damaging plumbing during teardown, or uncovering an issue behind the wall that you then have to pay a trade to diagnose anyway — which can end up costing more than the demolition labor you were trying to save.
Does a 5×7 bathroom need a permit to remodel?
Not for cosmetic work. Yes for plumbing relocation, electrical changes, or structural alterations. Confirm with your local Florida building department before starting.
Want to see how this compares to the full picture of bathroom remodel costs, or ways to bring your specific budget down? See our complete bathroom cost guide for the full breakdown.
Frequently Asked Questions About 5×7 Bathroom Labor Cost
Q1: How much is labour for a 5×7 bathroom remodel?
Typically $3,000 to $7,000, which is usually 40 to 60 percent of the total project cost.
Q2: How big is a 5×7 bathroom?
35 square feet. It is the standard American full bathroom size, normally fitting a toilet, a vanity and a tub-shower combination along the seven-foot wall.
Q3: What percentage of a bathroom remodel is labour?
Generally 40 to 60 percent. The share rises when plumbing is relocated and falls when the project is mostly fixture replacement.
Q4: Which trade costs the most in a bathroom remodel?
Tile setting is usually the largest single labour line, because it is time-intensive and the finish quality depends entirely on the skill of the setter.
Q5: Can I save money by doing demolition myself?
Some, but less than people expect — demolition is typically a small share of the labour. The bigger risk is damaging plumbing or discovering issues you then pay a trade to diagnose.
Q6: Does a 5×7 bathroom need a permit to remodel?
Not for cosmetic work. Yes for plumbing relocation, electrical changes or structural alterations. Confirm with your local Florida building department before starting.
Ready for a Real Quote?
Ready to see how these trade costs apply to your specific bathroom? Request an Estimate →